|
Post by usa1man on Feb 17, 2005 22:13:43 GMT -6
ok i am not saying im gonna do it but is it possible : to put a servo on each axel tube on a clod so 4 all together and wire them together to create a 360 degree turning radius. i am not sure but the way i am thinking it should work, i was going to put two servos per gear box so they both pull in towards the middile of the gear box at the same time if this is done to both gear boxxes it should work what do you think
|
|
|
Post by CampRacing on Feb 17, 2005 22:27:35 GMT -6
it will not work for it to work you would have to make the wheels on one axle spin in differnt directions like this ( note the arrows on the wheels) but this is what you wanted to do right?
|
|
|
Post by hcfr34 on Feb 17, 2005 22:28:01 GMT -6
I haven't seen any examples yet, but I have heard alot of people talking about it. I don't believe you can turn them in opposite directions unless they were on seperate channels on the radio with a self centering switch to return tires to center. I suppose you could use extra y connectors to get all 4 operational, but hooked up this way they would turn in the same direction. Good luck.
|
|
|
Post by usa1man on Feb 17, 2005 22:35:18 GMT -6
yeah i thought it would be something differnt but o well
|
|
|
Post by hcfr34 on Feb 17, 2005 23:13:21 GMT -6
You could still do a servo per wheel, they would have to turn in the same direction is all. The benefit is longer servo life, and more turning power per wheel.
|
|