|
Post by jimcrawler on Feb 15, 2005 12:14:55 GMT -6
;D can someboby maybe post a picture of how an installed 4 link setup connects to the axles? im using the esp lift kit w/ 8 shocks.(want that ol skool look).i know its a dumb question but its my first clod project. thanks in advance
|
|
|
Post by Rock Spyder on Feb 15, 2005 13:03:04 GMT -6
Easy set up for the Clodzilla 2..
Mount the links to the side of the Brace on the chassis. Use some Fuel tubing to take up the slack because of the large hole on the side.
Mount the other 4 links to the Bottom of the chassis.
Now the Bottom links go to the Bottom of the Axle Tube called the C hub section you will need to drill a hole in each of the bottom parts of the C hub. Remove the Stearing knuckle to gain access. You will see the Upper Mount brace screw just line up your hole and copy it on the bottom part.
Next if you look at your Axle Tube on the Clod Axle you will see 2 different places to mount the Upper links that come from the Side of the Chassis. 1 place is On the Axle brace itself at the farthest hole from the Gearbox itself.. Again use fuel line to take up the slack and washers to sandwich the peices together. Mount the link and reassemble the front and rear again.
2nd way is to use the exsisting screw location that is for the Axle brace, using a long screw and the ball end, add a few washers or nuts or Conical washers to keep from over extending the link from the side of the chassis. Line it up use a lock nut and tighten.
Hope this helps Tom
|
|
|
Post by jimcrawler on Feb 15, 2005 13:23:06 GMT -6
your the man, tom thank you
|
|
|
Post by Rock Spyder on Feb 15, 2005 18:59:54 GMT -6
No problem any more help if you need it just ask...
Tom
|
|
|
Post by hcfr34 on Feb 15, 2005 19:33:28 GMT -6
Holy on the ball batman.
|
|
|
Post by Rock Spyder on Feb 15, 2005 19:41:50 GMT -6
As the Skipper takes of his hat and WAPP! Down goes gilligan..
Tom
|
|